On the 5.2L and 5.9L V8 engines, rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.
2000 Dodge Durango Problem Reports
Newest 2000 Dodge Durango Problem Reports
If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.
Front and rear differential pinion seal leaks are common. A leaking pinion seal will require replacement.
Engine oil leaks at the distributor can be misdiagnosed as leaks from the intake manifold seal, oil pan gasket, or rear crankshaft (rear main) seal. A revised distributor is available if oil is found inside the distributor.
A ticking type noise may develop, most noticeable when the engine is cold. This is commonly caused by one or more broken exhaust manifold bolts. Our technicians recommend to replace the broken bolts as needed, also the exhaust manifold gaskets should be replaced at this time.
If the threads strip where the front brake caliper mounts to the steering knuckle, a steering knuckle repair kit is available. A new steering knuckle is not normally necessary.
External oil leaks from the valve cover gaskets, intake manifold gaskets (front or rear), and the rear crankshaft seal area are common. The rear main seal is an unlikely source. Normally, leaks in this area are from the bearing cap mating surfaces as well as the sealing surface between the oil pan and bearing cap.
If the door locks intermittently lock and unlock without pressing the door lock switch, the door and liftgate lock cylinder switches may need replacement. This may occur more often when driving in damp conditions like the rain or through a car wash.
On the 4.7L V8 engine, the Camshaft position sensor failure can cause the engine to crank but not start or it can cause intermittent stalling. A new camshaft position sensor will be needed.
One the 5.2L and 5.9L V8 engines carbon buildup on the top of the piston is common. As the buildup increases with mileage and over time, symptoms may vary from light ticking, to ticking/hammering, to hammering/knocking noises. Fuel injector cleaner often solves the problem.