» » »

Problems for specific Dodge Durango years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Newest reported 2000 Dodge Durango problems

 

Verified for the Dodge Durango

On the 5.2L and 5.9L V8 engines, rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.

1 Report
Me Too

Verified for the Dodge Durango

If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.

8 Reports
Me Too

Verified for the Dodge Durango

Front and rear differential pinion seal leaks are common. A leaking pinion seal will require replacement.

21 Reports
Me Too

Verified for the Dodge Durango

Engine oil leaks at the distributor can be misdiagnosed as leaks from the intake manifold seal, oil pan gasket, or rear crankshaft (rear main) seal. A revised distributor is available if oil is found inside the distributor.

6 Reports
Me Too

Verified for the Dodge Durango

A ticking type noise may develop, most noticeable when the engine is cold. This is commonly caused by one or more broken exhaust manifold bolts. Our technicians recommend to replace the broken bolts as needed, also the exhaust manifold gaskets should be replaced at this time.

120 Reports
Me Too

Verified for the Dodge Durango

Poor AC performance or no cold air blowing from vents is commonly caused by a refrigerant leak from the AC condenser. Road debris like rocks or pebbles can damage the condenser tubes.

16 Reports
Me Too

Verified for the Dodge Durango

External oil leaks from the valve cover gaskets, intake manifold gaskets (front or rear), and the rear crankshaft seal area are common. The rear main seal is an unlikely source. Normally, leaks in this area are from the bearing cap mating surfaces as well as the sealing surface between the oil pan and bearing cap.

8 Reports
Me Too

Verified for the Dodge Durango

The upper ball joints may fail due to moisture damage. Our technicians tell us 2000-2001 models were recalled for this issue. For more information on this recall, please click here»

3 Reports
Me Too

Verified for the Dodge Durango

If the door locks intermittently lock and unlock without pressing the door lock switch, the door and liftgate lock cylinder switches may need replacement. This may occur more often when driving in damp conditions like the rain or through a car wash.

11 Reports
Me Too

Verified for the Dodge Durango

On the 4.7L V8 engine, the Camshaft position sensor failure can cause the engine to crank but not start or it can cause intermittent stalling. A new camshaft position sensor will be needed.

16 Reports
Me Too

Verified for the Dodge Durango

One the 5.2L and 5.9L V8 engines carbon buildup on the top of the piston is common. As the buildup increases with mileage and over time, symptoms may vary from light ticking, to ticking/hammering, to hammering/knocking noises. Fuel injector cleaner often solves the problem.

1 Report
Me Too

Verified for the Dodge Durango
The power door lock switch can short circuit internally causing a battery drain and/or the key operated accessories to function even though the key is off. If the power door lock switch is diagnosed to be the cause, replacement of the switch should fix the concern.
2 Reports
Me Too
Ask a Question