2001 Dodge Dakota Problem Reports

RepairPal Verified 2001 Dodge Dakota Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

On 3.7L V6 and 4.7L V8 engines the camshaft position sensor may fail causing the engine to crank but not start or it can cause intermittent stalling. A failed camshaft position sensor will require replacement.

If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.

If the HVAC (heater) housing is not properly sealed at the bulkhead (firewall), water can leak into the passenger compartment. Foam sealant should be used to seal any gaps and the evaporator drain tube can be modified to prevent further water entry.

On the 3.9L V6 and 5.9L V8 the engine oil leaks at the distributor can be misdiagnosed as leaks from the intake manifold seal, oil pan gasket, or rear crankshaft (rear main) seal. A revised distributor is available if oil is found inside the distributor.

Exhaust manifold bolts commonly break, exhaust manifold gaskets should be replaced and replace bolts as needed.

If the threads strip where the front brake caliper mounts to the steering knuckle, a steering knuckle repair kit is available. A new steering knuckle is not normally necessary.

On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.

The upper ball joints may fail due to moisture damage. Our technicians tell us 2000-2001 models were recalled for this issue. For more information on this recall, please click here»

Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.

Front and rear differential pinion seal leaks are common. The leaky pinion seal and differential fluid will need to be replaced.

On the 3.9L V6, 5.2L V8 and 5.9L V8 the Oil leaks commonly from the valve cover gaskets, intake manifold gaskets (front and rear), timing cover gaskets, distributor O-ring, and the rear main seal area. Using fluorescent engine oil dye can be helpful in determining the source(s) of the oil leak.