1999 Dodge Dakota Problems

RepairPal has identified the most common problems with the 1999 Dodge Dakota as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
14
Known Problems

On the 3.9L V6 and 5.2L V8, rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.

Fuel pump failures are common on higher mileage models, Resulting in a crank no start condition.

Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.

3.7L V6 and 4.7L V8
Exhaust manifold bolts commonly break, exhaust manifold gaskets should be replaced and replace bolts as needed.

If the engine cranks but does not start, or starts and stalls, the fuses should be inspected, especially the power door locks fuse. The power door lock fuse provides power to a module that sends the Powertrain Control Module (PCM) the "OK to start" signal.

If the threads strip where the front brake caliper mounts to the steering knuckle, a steering knuckle repair kit is available. A new steering knuckle is not normally necessary.

On the 3.9L V6, 5.2L V8 and 5.9L V8 the Oil leaks commonly from the valve cover gaskets, intake manifold gaskets (front and rear), timing cover gaskets, distributor O-ring, and the rear main seal area. Using fluorescent engine oil dye can be helpful in determining the source(s) of the oil leak.

The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops.  There is also a revised vacuum check valve available to address this concern.

Front and rear differential pinion seal leaks are common. The leaky pinion seal and differential fluid will need to be replaced.

On the 3.9L V6 and 5.9L V8 the engine oil leaks at the distributor can be misdiagnosed as leaks from the intake manifold seal, oil pan gasket, or rear crankshaft (rear main) seal. A revised distributor is available if oil is found inside the distributor.

On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.

On the 3.9L V6 and 5.2L V8 it is often misdiagnosed as a leaking oil filter gasket, the oil filter adapter can seep from between the adapter and engine block.

A loud buzzing or whining noise when the transmission is in reverse may be caused by the regulator valve in the transmission valve body. A revised regulator valve was released that does not resonate. Careful diagnosis should be performed because other issues can create this same type of noise.