» » »

Chrysler Q&A

Ask Your Question

2010 Chrysler Sebring Question: Do you need to use software to reset the electronic system for the car to run?

 

Question

graywolf2, 2.4L 4 Cylinder, Sumter, SC, May 24, 2013, 12:53
 Rookie

Car doesn't run now. Had new cam sensors installed and codes cleared. Check engine light stayed on. check shows no current or pending codes just old ones. car will run just fine for 10 or 15 miles including freeway speed then cuts of and won't restart. After several minutes it will restart in park but as soon as you put it in drive it cuts off

2 Answers
Flag This
  • Answer #1

    Greg's Orange Auto (13211 Answers) , Orange, CA - (714) 361-9386
    globalhelper May 24, 2013, 13:14
     Master

    CK FUEL PRESSURE TO START WITH. POSS UNDER 3YR 36K MILE DEALER WARRNTY?

    Flag This
  • Reply

    graywolf2, May 24, 2013, 13:46
     Rookie

    OUT OF WARRANTY. The shop may have checked the fuel pressure. I'll check with them. Thank. By the way is there an in line fuel filter between the tank and the engine?

    Reply
    Flag This
  • Answer #2

    pushrod May 24, 2013, 14:21
    Profile_thumbnail
     Master

    I think you have a CRANKSHAFT sensor problem! What kind of SCANNER was used? A scanner, not a code reader, can reset all adaptves and monitor crank/cam sensor input signal when not starting while cranking engine over. (No in line fuel filter)

    Reply
    Flag This