When trying to start - it is like it isn't getting gas.
Ford Q&AAsk Your Question
2000 Ford Taurus Question: Dies in 50ft Then won't start. Let sit for awhile & then starts. New gas Filter
Answer #1patrick mannion from Greg Solow's Engine Room, December 21, 2011, 10:01Master
You need to determine when it stalls are you loosing spark or fuel. Check for spark first, get a friend to crank over the engine when the engine has failed and see if you have spark at the spark plug end of the plug wire. Check for fuel pressure (you will need a fuel pressure gauge and look up the specified fuel pressure for your vehicle). Remove the fuel hose that goes to the fuel rail and get a friend to crank over the engine to see you have adequate fuel volume (you should have approximately 1 pint of gasoline in ten seconds of cranking). Off course take proper precautions as gasoline is highly flamable. Next "listen" to the fuel injector. Using a mechanic's stethoscope (or use a long screw driver placing the handle end up to your ear place the metal tip end of the screwdriver against the body of the fuel injector), get a friend to crank over the engine while you "listen" to the fuel injector listen to each injector at the same point of the injector body. You should hear "click, click, click" as the injector is electrically opened and closed by the computer. If the injector is not being triggered you will not have fuel getting into the engine's cylinders. Disconnect the electrical connector at the fuel injector with the ignition key in the "on" position, (next position after the accessory position) you should have 12 volts at one of the two wires at the injector. This true for most vehicles but you need to consult a workshop manual for your vehicle to see that this is true for your vehicle. When the engine is running the second wire at the injector gets (triggered) grounded by the computer in your vehicle many times a second controlling exactly when and how much fuel gets injected into the engine. For more detailed test information there is a company that independent auto repair shops get their information from, this same information is available inexpensively for people that work on their own cars.. The information is year make and model specific, covering repair procedures, torque specifications, fluid capacities and specifications, service bulletins, component locations, wiring diagrams ect.... Alldata is very easy to navigate http://bit.ly/AllData_Repair_Manuals_Online
ReplyFrank Edwards, December 21, 2011, 10:06Rookie
Thanks a ton.
I will check these solutions out tonight after work.