Q&A

2002 Chrysler PT Cruiser

Question: diagnostic trouble codes

Question

nycjoe63, 2.4L 4 Cylinder, Virginia Beach, VA, March 10, 2010, 19:08

 Rookie

my pt will not start and is generating trouble code po320.i have fuel pressure .i do not have spark.i have voltage at the ceank sensor .will replacing the crank angle sensor solve my problem?

2 Answers

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  patrick mannion from Greg Solow's Engine Room, March 10, 2010, 21:21
  

   Master

  Found this link
  http://www.ptcruiserlinks.com/forum/general-pt-cruiser-di...
  Reply
  Flag This
  Like | 3 people like this3
• Answer #2

  Visitor, December 09, 2010, 12:52

  yes replace crank senor
  Reply
  Flag This
  Like0

• My car dosen't want to idle when the air cond.is on.It gives me a code of po301
  I changed the plugs & wires and it stilles gives me the po301 code. Could it be the idle control valve. Please tell me how to change it. when i changed the plugs the #1 & 3 plugs had a burnt electr...

  Q&A > Chrysler > 2007 Chrysler PT Cruiser

• engine light
  never had codes checked.does autozone have a machine that cheaks codes?when AC is on it feels like a heavy load comes and gos like the compresor locking up. light comes on just when it starts to st...

  Q&A > Chrysler > 2001 Chrysler PT Cruiser

• battery light on (and check engine light on) with new battery, is it the alternator?
  I have a 2005 pt cruiser base with 58000 miles, so i turned on the car the check engine turned on , but I kept driving and at my street corner my battery light turned (also i felt that it had troub...

  Q&A > Chrysler > 2005 Chrysler PT Cruiser

• my 2004 at times wont take fuel
  Some times when I am going down the road the car misses an wont take fuel. Push on the gas an it just like it runs out of gas bogs down but it still runs it dont die. You try to give it gas it wnt ...

  Q&A > Chrysler > 2004 Chrysler PT Cruiser

• rear wiper
  rear wiper inop through steering column control but motor works if powered seperately, does it need new control? Also how do you access auxillary jack on radio for mp3 player connector is loose?

  Q&A > Chrysler > 2006 Chrysler PT Cruiser