had car put on computer codes kicked out are PO106, PO109, PO171, PO300, PO316 and P2195. Have changed O2 sensor, spark plugs and checked all air lines. Car was running rough, did the above, car thumped and now runs smooth. What caused this and what else needs to be done?
diagnostic codes on 2005 Ford Escape
by boro5872 in Rison, AR on September 10, 2009
ANSWER by Oakman on September 11, 2009
If your 2005 Ford Escape is running OK now the next step would be to have all the fault codes cleared from the engine control computer. After the codes are cleared watch for any new driveability concerns and keep any eye on the check engine light. If the engine begins to run poorly again or the check engine light comes back on you should check the codes again to see what code(s) have set, diagnose the code(s) and repair accordingly.
ANSWER by Visitor on May 20, 2010
yes it donot want to start up
Check engine light is on. Just tuned up, plugs, filter, fluid levels ok. Diagnostic code shows P0401. What does this mean? What are probable fixes?
So the escape has been idling rough off and on for a while with the occasional stall. then one day we get on the free way and the vehicle starts stubling pretty bad and we get off. stumbles all t...
Thanks for your list of common problems, based on Code P0171, now can you direct me as to what to do next? Autozone did reset light, and is has not come back on @ this time. What should I do now? ...
diagnostic code is p3505
My problem is a very fast idle when in park and when in drive the vehicle goes 30-40 mph on its own. Also, the emission system warning light is on. I know nothing about a diagnostic code or where u...