Dodge Intrepid Problem Report
Dodge Intrepid Damaged Cam Position Sensor May Cause Engine Problems
A damaged cam position sensor (or its wires and connector) can cause intermittent stalling, stumbles, or hard starting.
Same on going issue up in Canada with the intrepid ,, intermittent hard starts, intermittent stalling when stopped to long at light or stop sign,, cruise would not work intermittently,,sluggish on excelleration,, sputter also, changed crank sensor and cam shaft sensor with after market parts according to readings on check engine light, resolved issues temporarily. All signs returned , check engine read camshaft sensor again,, changed cam shaft sensor once again with aftermarket,, 8 months later same symptoms, progressively got worse would take up to 6 cranks of the key to start and it would run poorly!!! Read check engine light which had also become intermittent! Just said random misfire! Took a chance on all I have read on internet and purchased dealer camshaft sensor ,, installed and so far ever ting is running correctly , no engine light, cruise is working all is good,, I'll keep you up to date! - Visitor
car shot off when i drive - Visitor
camshaf sensor code but i replace it - Visitor
car will not start with sensor plugged in what can I do I replaced the cam sensor, why don,t u answer me I,m stuck with a junk and it,s not funny - Visitor
engine cranks but will not start,then some time it starts right up? - Visitor
car will not start sometime on one turn,and it vibrates slightly - Visitor
GOING ON EXPRESSWAY ENGINE JUST DIED, HAD TO HAVE SENSOR REPLACED. - Visitor
car choked and stalled, then engine light went on with this error code. 140 to fix. then the next day the radiator went. then the thermostat was broken too. $140, $340, $180....bought the car for $1200. ugh. - Visitor
in the process of getting fixed. was just diagnosed the other day - Visitor
Cam sensor got too close and end shorted. Replaced with aftermarket - intrepid2001
The car doesnt always want to start, check engine light on and had it checked to see what code it showed and it said cam shaft position sensor so i bought one and hopefully that fixes the problem. - Visitor
Car began stuttering and then dies, at some points does not want to start on first attempt. Electrical works fine seems the engine will simply shut off. - Visitor
When a no start condition is caused by a faulty camshaft or crankshaft sensor, related fault co...
Sometimes while driving the car will die, just the engine, electrical ok. Often it is hard to s...
My 1999 Intrepid has 222,000 miles on it. Recently I had some sensors in the transmission fixed...
Car will on occassion not start when the engine is hot. This is becoming more ofter. In additio...
had water pump replaced along with timing chains, now car will only get up to 2400-2500 rpm and...