Where is the crankshaft position sensor located? I know it could be in 2 different places. I just want to know like where at on the engine block it could be because I just got my harmonic balancer replaced and now the sensor is bad and I don't want to have to take it off again if the sensor is not behind it.
Crankshaft position sensor on 2005 Chevrolet Impala
by Visitor in Winter Haven, FL on January 31, 2011
1 answer 2 comments
ANSWER by patrick mannion on January 31, 2011
Crankshaft position sensor A is behind the harmonic balancer. crank position sensor B is left rear of engine. Sensor A has three wires red, black, green, joining light green, yellow /black and blue/ black.
COMMENT by Visitor on January 31, 2011
ok another question. I took my car to autozone and they told be it was bad but didnt tell me which one. My guess is the one behind the balancer because my balancer broke off due to my power sterring had a leak and i'm guessing also leaked onto that sensor. What do you think?
COMMENT by rc parts on February 01, 2011
a3.4has a24xsensor is mainly fuel timing and#1 resset ignition alsoknownascam pos. then a cranksensor for 1/4/2/5/3/6pulse will causeano start or engine stall 24x sensor will most likely stay running but have extended cranking with a very sluggish accelaration
The mass air flow or crankshaft position sensor may fail causing the engine to intermittently stall. It may be necessary for the engine to coo...
The crankshaft position sensor, ignition module, and/or powertrain control module (PCM) may fail resulting in illumination of...
...my daughter take it to the mechanic her grandparents use and they said it checked out as a bad throttle body? Does this make sense. What about the crank and cam codes?? is this a common problem. this all...
where is the position of the crank sensor on the 2005 impala. Is it hard to do it yourself?
car was running fine then the belt staped due to to power steering pump now it wont start