crankshaft position sensor on 1998 Cadillac Catera

is the crankshaft position sensor located right next to the oil filter and is about the size of a nickle with a tab and one bolt holding it on ? if so how do you get to the outher side ? it looks like i need to losen the exaust and hope i can reach the outher end???

by in Brooklyn, CT on March 07, 2010
2 answers
ANSWER by on March 07, 2010
Alldatadiy.com is where I would go to get service info for this car. It costs a little but is worth it.
ANSWER by on January 25, 2011
yes and the wiring is connected at the top of the valve cover just pull it out making sure you get all the peices out because its tightly wedged in between the oil pan and the trans and the new one would be a lot easier to put in
Related Items:
...UBLIC "-//W3C//DTD HTML 4.0 Transitional//EN" "http://www.w3.org/TR/REC-html40/loose.dtd"> The crankshaft position sensor may fail causing the engine to stall while driving and/or will crank but not start, especial...
...in catalyst below threshold(bank 2) p1700 manufacture control transmission po335 crankshaft position sensor A circut malfunction, after it read these codes i cleared it drove it about 5 miles and it s...
...ait a bit and restart it it will run for a short thim and do it agine i think it maybe the crankshaft position sensor ??? if so were is it and how do i change it
it will not start. I also replaced the spark plugs. when it shut off the gas cap light came on, unscrewed it and put it back on nothing happens. acts like it wants to turn over but won't. what do y...