» » »

Audi Q&A

Ask Your Question

1993 Audi 90 Question: cranks wont start

 

Question

0salva, 2.8L V6, San Diego, CA, May 17, 2011, 20:07
 Rookie

had engine rebuilt it turns but wont start their is fuel and spark change the crank senso checked the rpm sensor

2 Answers
Flag This
  • Answer #1

    patrick mannion from Greg Solow's Engine Room, May 17, 2011, 23:12
    Profile_thumbnail
     Master

    It's best to follow trouble shooting procedures found in the workshop manual to check for mechanical integrity (able to develop compression, components in synchronization ect..... ) and check for spark and fuel system integrity. Autozone have some popular workshop manuals for free on line once you register (for free) on their website http://bit.ly/autozone_repair_info. There is also a company that independent auto repair shops buy their information from that the same information inexpensively to do it yourselfers. The information is year make and model specific repair procedures, service bulletins, component locations, wiring diagrams ect.... Alldata is very easy to navigate http://bit.ly/AllData_Repair_Manuals_Online

    Reply
    Flag This
  • Answer #2

    modeauto from Mode Automotive Repair, May 26, 2011, 12:13
    Profile_thumbnail
     Technician

    Do you have injector pulse? If you have injector pulse, spark, and fuel pressure, next I would check to see if mechanical timing is off, maybe was set few teeth off incorrectly during rebuild. Hope this helps.

    Ryan Mode
    Mode Automotive 858-361-4645

    Flag This
  • Reply

    Visitor, May 26, 2011, 12:41

    had timing check using both of the tools cranks gets locked and cyl 3 is up there is injector pulse had the pressure checked compression is at 199 ea. cyl it tries to start just that it dies out thanks

    Reply
    Flag This
Answer Ranks