Dodge » Ram 1500 » 2007 Dodge Ram 1500 » Questions

Q&A

Ask Your Question

2007 Dodge Ram 1500

 

Question: Cranks but will not start.

Question

Pennybear1, 4.7L V8, North Ridgeville, OH, February 23, 2013, 13:46
 Rookie

The starter cranks but will not start. If I spray fuel into the intake it will run. If i leave it sit for awhile it will start right up. And run great. I can hear the fuel pump so I dint think it's that I have checked the fuses. The wireless door locks work so I don't think it is the security system. If it din't run at all I would think it would be the fuel pump but it will run some times. If it sets over night it would start. I can drive it all day shut it off and it would fire right up if I leave it for about 1 hr it will not start. Got to be something simple.

2 Answers
Flag This
  • Answer #1

    Randico February 23, 2013, 15:05
     Enthusiast

    If you spray fuel into the intake you definately have a fuel problem, You may not have a check engine light but you definetly will have a pending check engine light, There are 2 sensor that are capable of causing your hard start up, One is the crank position sensor it is used along side with the cam position sensor, these are used by the PCM to synchronize ignition and injection timing, If either one is out of range you wont start up. The location for the CKP is mounted into the side rear of engine block, The CMP is located passenger side cylinder head,exhaust side near front

    Reply
    Flag This
  • Answer #2

    donjr February 24, 2013, 04:54
     Rookie

    dose it start if you hit bottom of tank with hammer when its cold????? if so bad or weak pump or messed up sock...

    Flag This
  • Reply

    Pennybear1, February 24, 2013, 07:12
     Rookie

    Well I did the hammer trick and nother happend just cranked and cranked. I think I might go ahead and just change the cam sensor. It just seems to be pionting to either the cam sensor or the crank sensor and since the cam sensor is at the front of the engine it looks like the best place to start. Well I have now replaced both sensors and still no start. Now what, The computer?

    Flag This
  • Reply

    Randico, February 24, 2013, 19:44
     Enthusiast

    Cycle the key and listen for a fuel pump noise it should humm,if you dont hear it let me know,

    Reply
    Flag This
What are Top Shops?
  • Verified
    Quality Work
  • Guaranteed
    Fair Prices
  • Happy
    Customers
Top Shops Near You
Answer Ranks