If the engine cranks but does not start, it may be caused by a tripped inertia switch. Switch the key to "ON" and the fuel pump should be heard running for a second or two. Listen at the gas filler if necessary. The inertia switch is located on the firewall and can be tripped when the parking brake is set too hard and then released. The inertia switch should be reset, and will click when it is reset.
Crank but No Start Condition and No Fuel Pressure on Mazda B2300
Average mileage: 99,018 (17,000–220,000)
Engine affected: 2.3L 4 Cylinder
26 people reported this problem
4 people shared problem details
5 speed engine died while driving down road and will not start? I had to call tow truck, and it was working fine before.
2002 Mazda B2300Visitor
turns over but act like no fuel
2006 Mazda B230046,000Visitor
Fuel safety switch keeps tripping while driving. Twice almost rear ended by this switch
Running, vehicle stopped, crank, does not start, wait 5 to 10 minutes. It will start, run for a while than it will shut off while driving
I put the key in, push the clutch to the floor, turn the key to the start and it sometimes does...
The engine won't start sometimes. The motor turns over very fast but won't crank. This happens...
after driving about 20 miles engine will not start when left over night it starts and then die again
Why do I keep blowing my relay ignition fuse Mazda B 2300 series pick up truck every time I turn the key in engage the clutch to start the truck blows the fuse
It's no crank no spark situation I believe it's a 7.5 amp fuse. If somebody could please help m...
got a 1994 b2300 mazda truck turns over wont start, changed battery, plugs, wires, starter, ign...