Corrosion of the Fuel Tank Harness Due to Water Leak on Chevrolet Uplander

Corrosion at the fuel tank to body harness may cause the Check Engine Light to illuminate or a crank no start condition. This corrosion issue is most commonly caused by a water leak inside the vehicle. Any damaged wiring or connectors will require replacement.

RepairPal Verified
Average mileage: 118,216 (52,000–189,296)
4 model years affected: 2005, 2006, 2007, 2008
10 people reported this problem
3 people shared problem details
Mine feul tank can not get under a fourth of tank or my will run out gas! So strange it visibly clear i have gas in the tank but it still will run out gas with out being close to E! Dont let me be on a hill! It wont starte either!
main wire harness runs under driver's seat and plugs into the floor in front of rear seat. The connection inside the van and underneath connectors are corroded. THERE IS A SMALL PLATE COVERING THE INSIDE CONNECIION. This is an easy removal. simply drill out two rivets and the plate comes off. Finding a non-corroded connection in a junk yard is difficult.
I was told is a harness or something in my gas clearly says I have a quarter tank....but it's out of gas
Related Items:
van will not start unless i mash the gas and i would also like to no how to change the canister...
After that I've changed a new mass air flow sensor and start the engine the still on. I would t...
Why has my mileage dropped? Dealership says everything looks good and supposedly checks out, si...
My tanks full reads only 3/4 full turn van off and back on then it reads full for a little whil...
I have water leak when it rains on my front floor can it come in the vents below winshield

Related Content