Chevrolet » Blazer » 2001 Chevrolet Blazer » Questions

Q&A

Ask Your Question

2001 Chevrolet Blazer

 

Question: coolant temp. sensor

Question

wes121102, Alcoa, TN, April 11, 2009, 16:46
 Enthusiast

I have a 2001 chevy s10 blazer 2 wheel drive with the 4.3 vortec. I need to replace the coolant temp sensor. Where is this located? Thank you

1 Answer
Answer It
Flag This

  • Answer #1

    fernando April 11, 2009, 17:16
     Master

    The Coolant Temperature Sensor or ECT sensor for the gauge is in the drivers side cylinder head between the front two spark plugs. Use care and allow enough time for the engine to cool before removing the ETC sensor. You will need to refill the cooling system.
    Bellow a picture from a repair manual
    http://bit.ly/40yBqj

    Flag This

  • Reply

    wes121102, April 11, 2009, 18:51
     Enthusiast

    Thank you very much for your help.

    Reply
    Flag This
Related Items:
  • are there 2 temp sensors for this vehicle.
    one for the computer and then another one. if so could you tell me where the other sensor is for the computer

    Q&A > Chevrolet > 2001 Chevrolet Blazer

  • over heating
    i have a 2003 blazer 4.3 4x4 it seems to run around 220 degrees i have changed thermosate and flushed system,fan clutch has been replaced also. but stills runs around 220 degrees do you have any s...

    Q&A > Chevrolet > 2003 Chevrolet Blazer

  • Why does my Blazer stall in hot weather only?
    I have a 98 Blazer that has plagued me for months on end. I installed a new fuel pump, dist cap, rotor, wires, plugs, crank sensor, coil, ignition module, swapped the MAP, cleaned the MAF, new filt...

    Q&A > Chevrolet > 1998 Chevrolet Blazer

  • No heat
    I have changed thermo twice, core, coolent twice, and coolant temp sensor. and I still have no...

    Q&A > Chevrolet > 1998 Chevrolet Blazer

Answer Ranks

This week's top 10

1 globalhelper 6 csubak30
2 pushrod 7 wenyan
3 ziptie12 8 goodguy
4 ChevyASE 9 tdtoolbox
5 gearhead89 10 Jamesw