Q&A

1996 Chrysler Sebring

Question: code problems

Question

pcc1, 2.5L V6, Blackshear, GA, January 25, 2011, 10:31

 Rookie

no buS keeps popping up, my gauges ALL quit and come back on any ideas??

1 Answer

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  Johnny Mopar January 25, 2011, 15:35
  

   Master

  You likely have a wiring problem on the Vehicles Bus circuit. I Bus circuit connects all of the vehicles Modules so they can communicate with each other. If the Bus goes down, the Modules cannot "Talk" to each other and components controlled by these modules stop working. The cause may be as simple as a loose, dirty or corroded wiring conector
  Flag This
  Like | 1 person likes this1
• Reply

  pcc1, January 26, 2011, 06:44
  

   Rookie

  have any idea WHICH connector? main computer, tail light, etc
  Reply
  Flag This

• p0335 code, will not start
  This is a 3.0 LXI coupe model. The car would not start, then after a few cycles of the key started up. Now it will not start at all. I replaced the crankshaft position sensor and have the car toget...

  Q&A > Chrysler > 2001 Chrysler Sebring

• Check Engine light with error codes
  ...engine light with 3 codes. P0304 misfire in cylinder. then 2 codes about intake and exhaust cam sensor slow response. it almost stalls at idle speed.

  Q&A > Chrysler > 2007 Chrysler Sebring

• Code P0455 and Shut off while in park
  I just bought a 2002 Chrysler sebring LXI and I have a code P0455. And while I was sitting the car shuts off it did this two times since I have bought it. I wanted to know what could this be. And h...

  Q&A > Chrysler > 2002 Chrysler Sebring

• po740 code
  no problems with trans, code comes on after @ 20 miles. po740 code

  Q&A > Chrysler > 2001 Chrysler Sebring

• Hard to start, rough idle, hesitation error code 0300
  Hard to start, rough idle or will not, hesitation, error code 0300. Once up past idle speed of maybe 1200 rpm runs fine. 2.4L

  Q&A > Chrysler > 2005 Chrysler Sebring