clutch on 2006 Mitsubishi Eclipse

Do you need to drop the engine on a 06 eclipse to replace the clutch?

by in Las Vegas, NV on April 12, 2011
1 answer 2 comments
ANSWER by on April 12, 2011
no, you need to remove the transaxle assembly. thanks for using repairpal Roy
COMMENT by on April 12, 2011
thank you! I bought this car for my son and I raise him alone(mom). We are assuming it is his clutch because it starts, goes into gear but doesn't move when you step on the gas. I was wondering what parts do I need to purchase, I was told the flywheel and throw out bearing needed to be replaced along with the clutch? Thanks
COMMENT by on April 12, 2011
it sounds like you are correct. you need a clutch kit which has disc, plate and bearing. flywheel may or may not need to be replaced. it depends on how badly it is hot spotted. make sure you get fluid for the trans as well. you will loose fluid in the process. Roy
Related Items:
Just received 2 vague diagnostics from untested mechanics. (Ours retired) 1st: “Clutch is bad.” 2nd: “Transmission is making the noise & must be replaced, but the clutch may be bad...
i have full clutch pedal and pressure but car only moves when the rpms are very high it doesnt...
A rattle noise may be noted from the clutch area while the car is at idle. If the noise changes or goes away when the clutch is depressed...
my master clutch cylinder, & the slave, were replaced too, both are new, why my shifter feels hard to get into...
My clutch has been replaced, with a new one, but I have kind of hard time to put in gear, the shift is h...

Related Content