clutch on 1999 Ford Explorer

clutch will not engage

by in Unionville, NY on June 02, 2010
1 answer
ANSWER by on June 02, 2010
is the fluid ok in the master? if it is, then you may have a failed clutch assembly. part of the throwout bearing is the slave cylinder. you need to make sure the slave is moving the fork inside. remove the rubber boot at the trans and have someone push the clutch pedal to see if there is movement. if there is, then you need a clutch assembly. runs about600-700 at our shop. Roy
Related Items:
...much. When I drive me vehicle from up the mountain down, say 45 minutes worth of driving. My clutch will almost refuse to go into 1st gear, 2nd gear, or reverse. Its only when i shut off my veh...
I was driving my 1991 Ford Explorer XLT when I pressed the clutch in to shift into 5th gear it went to floor and it lost all pressure to it. After that I could...
how do i remove clutch master cylinder it wont go any farther and just feels like it lost a spring or something it is not engaging clutch at all it does nothing anyone got any ideas thanks
Is it possible to tighten up the clutch cable and if so , Where can the adjustment screw be located?

Related Content