» » »

Isuzu Q&A

Ask Your Question

1992 Isuzu Rodeo Question: clucth

 

Question

choas3050, 3.1L V6, Cincinnati, OH, April 08, 2009, 14:41
 Rookie

i have replaced the clutch master slave cylinder and hydraulic lines still cant get into gear when running but when off it will go in gear and will start but cant get very good pedal

3 Answers
Flag This
  • Answer #1

    Bret Bodas from RepairPal Test Shop, September 16, 2009, 13:25
     Master

    Hello, did you have to replace the clutch to fix this problem?
    Thanks!

    Reply
    Flag This
  • Answer #2

    Visitor, June 25, 2010, 18:31

    did you blead the clutch line

    Reply
    Flag This
  • Answer #3

    Frank Angeloni January 16, 2011, 09:09
     Rookie

    Did you check the Free play at the pedal after bleeding?. Because you can get gears with the engine OFF suggests lack of clearance between the pressure plate and the driven plate. Top of clutch pedal under dash is an adjuster bar. loosen locknut and EXTEND the bar 6 flats, retry,and so on until you have a clutch pedal height (level with brake) and a smooth slide into 1st cog. Good luck.

    Reply
    Flag This