clear code on 2000 Acura RL

I plugged in my code reader, and it showed no faults, but the maintainence req. light stays on, even when I erase through the reader?? what to do?

by in Elk Grove, CA on March 22, 2011
2 answers
ANSWER by on March 22, 2011
different system. try this, push in and hold the trip reset button, turn key to on position until the light goes out. turn key off and then start the car. it should be off. Roy
ANSWER by on March 23, 2011
Maintenance required light is a timed light indicating you're due for your routine maintenance. (approximately every 7500 miles on this car) Such as an oil change or multi-point inspection and service based on your miles. Make sure your service is performed and your technician resets the light afterwords.
Related Items:
any time there is weight on the passenger side seat and i start the engine, the light comes on and the alert keep beeping, but if i start the engine first and put weight on the seat, it doesnt blin...
The Check Engine Light may illuminate due to failure of the exhaust gas recirculation valv...
I disconnected battery and, check engine light was off until I got up to 45 mph and light came...
vehicle seems to run properly just a little loud in idling. Getting 21 to 22 mpg on the highway. 19 to 20 in the city.

Related Content