Upon deployment the driver's front airbag inflator could rupture, increasing the risk of personal injury. Dealers will replace the driver's front airbag inflator to correct this concern. Note: this recall supersedes, in part, recall #14V-354.
If the ignition key unexpectedly moves to the OFF or ACCESSORY position, the engine will turn off. This will depower various safety systems including but not limited to airbags, power steering, and power braking. Loss of functionality of these systems may increase the risk of crash and/or injury in the event of a crash. The weight of extra items on the ignition key ring can be a contributing factor to this unexpected occurrence. Until this recall is completed customers are advised to remove all other items from the ignition key ring. Dealers will modify the ignition switch to correct this concern.
This limited regional recall is for vehicles currently registered or first sold in Florida, Puerto Rico, Hawaii and the U.S. Virgin Islands, and equipped with Takata-brand air bag inflators. Upon deployment the driver and/or passenger airbag inflator could rupture, increasing the risk of personal injury. Honda dealers will replace the affected airbag inflator modules to correct this concern.
Certain All Wheel Drive (AWD) vehicles equipped with a ZF 8HP45 transmission are being recalled. In the affected vehicles, the transmission output shaft can break unexpectedly. This could result in loss of power to the drive wheels, increasing the risk of a crash. The vehicle could also unexpectedly roll away with the transmission shifter in the park position. Dealers will replace the transmission in affected vehicles to correct this concern.
522 vehicles equipped with a 2.4L engine are being recalled because the engine may have abrasive debris in the balance shaft bearings. The debris can result in premature wear and loss of engine oil pressure. As a result, the engine could stall unexpectedly or fail. Dealers will replace the engine balance shaft module to correct this concern.
The incorrect software may have been installed in the occupant restraint control module (ORC). As a result, the airbags may not deploy as expected in the event of a crash. Improperly deployed airbags can increase the risk of personal injury. Dealers will inspect and replace the ORC module as necessary to correct this concern.
The occupant restraint control module monitors vehicle occupant and crash data to determine which airbags to deploy when necessary. A software error may result in the airbags deploying from the opposite the side of impact (a left side impact would deploy the right side airbags and vice versa). This would leave the occupant at the point of impact with no protection, increasing the risk of injury. Dealers will reprogram the occupant restraint control module to correct this concern.
Active head restraints are designed to move forward and upward as necessary in the event of a rear end collision. These vehicles are being recalled because an internal fault in the occupant restraint control module could cause the active head restraints not to function as expected, increasing the risk of injury. Dealers will reprogram the Totally Integrated Power Module (TIPM) or replace the occupant restraint control module as necessary to correct this concern.
The supplemental restraint system, commonly called the "airbag", consists of several "bags" that are very quickly inflated to help protect the vehicle occupants in the event of a crash. An on board computer uses information from various sensors to determine if and when the airbags should deploy. The affected vehicles may have a poor electrical connection in the front seat which could affect deployment of the side airbags and/or cause the airbag warning light to illuminate. Dealers will replace the airbag withing harness in both the driver and passenger front seats to correct this concern.
The nut securing the rear axle pinion my loosen because an adhesive patch was not installed during vehicle assembly. If the nut loosens, the axle can lock up with little warning, resulting in a loss of vehicle control and/or a crash. Dealers will install a pinion nut retainer to correct this concern. This is an expansion of a previous recall, NHTSA number 12V474000, Chrysler number M34. The Chrysler recall number for this recall is N08.