2008 Chrysler Town & Country Problem Reports

RepairPal Verified 2008 Chrysler Town & Country Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

A defective anti-lock brake system (ABS) pump and/or leaking piston seals in the master cylinder can cause excessive pedal effort, lack of stopping power, and abnormal pump noise. Diagnoses will be required to determine the root cause of any braking issues and the component(s) that will require replacement.

Headlight switches can fail, causing the headlights to intermittently stay in the on or off position. Repeatedly turning the switch on and off may temporarily fix the problem. Replacement of the switch is needed to resolve this issue. 

Worn sway bar bushings or sway bar end links may cause a rattling or clunking noise from the front suspension during low-speed driving. Though not always the root cause, front struts are often replaced for this condition.

The front legs for the third row bench seat may not retract. Our technicians tells us a new parts kit and/or spring is available to correct this concern.

There have been reports of excess oil consumption due to oil burning in the combustion chamber. This can be occurring even without the traditional blue oil smoke noted from the tail pipe. In some cases this oil consumption is due to problems with the PCV system. It is recommend a complete inspection of the PVC system, including this oil baffle inside the valve cover, be performed if excess oil consumption is noted. According to the manufacturer, usage of 1quart of oil every 1,000 miles is acceptable.

A problem with the sliding door track and door stops can allow the door to slide out of the track and fall off the vehicle. This is more common when doors are opened fast and allowed to hit the stops with a lot of force.

Some vehicles may develop a musty odor coming from the HVAC system, Dodge has issued a cleaner/disinfectant and a coating for the evaporator designed to inhibit bacterial growth.

If the heater is on and no heat is felt from the right side dash vents, there may be a problem with the blend air door shaft; a revised part is available to address this concern.

V6 engines may experience surging while driving. The condition is more noticeable between 40 and 50 MPH while accelerating up a hill/slight incline. Replacing the powertrain control module (PCM) and updating the transmission control module (TCM) software may be required.

A "tapping plate cage" on the driver side frame rail may cause a squeak or tick noise while driving, this is often misdiagnosed as a suspension problem. The tapping plate is a threaded plate which accepts one of the front sub-frame mounting bolts. The "cage" of the threaded plate may be touching the frame rail causing noise as the vehicle is driven. "Adjusting" the rear tab on the tapping plate cage so it no longer is touching the frame should eliminate this noise.

One or more power windows may stop working due to a failed regulator or motor which will require replacement. Our technicians tell us the regulator and motor is replaced as a set on these vehicles.

Excessive oil consumption—defined as more than one quart per 1,000 miles (on vehicles with less than 50,000 miles) or more than one quart per 750 miles (on vehicles with more than 50,000 miles)—is common. Common causes include exhaust valve guides, valve cover gaskets, camshaft plugs, camshaft seals, and crankshaft seal.

The Check Engine Light may illuminate for many different reasons, some of which may be corrected by updating the software in the powertrain control module (PCM).

Intermittently, the key may not start the car or release from the ignition. If it is excessively worn, replace the key. If the new key doesn't work, replacing the lock cylinder including tumblers should correct this concern.

Shifting harshness and shuddering issues related to the operation of the automatic transmission have been addressed by factory service bulletins. The shuddering can feel like the vehicle is being driven over rumble strips.