Power Sliding Door will open, but stops shortly after. Will not close except manually. Found a broken wire in the chain-looking wiring harness under the door. Repaired the wire, and it works great again.
Problems for specific Chrysler Town & Country years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2008 Chrysler Town & Country problems
I have had the Van for 2 months. The A/C was hissing and then blowing warm air. Lucky still have the manufactures warrenty and I am told the rear evaporater needs to be replaced. I am still waiting for this part to arrive so far 1 week has passed and it will be July this week. I need this fixed asap.
Headlight switches can fail, causing the headlights to intermittently stay in the on or off position. Repeatedly turning the switch on and off may temporarily fix the problem. Replacement of the switch is needed to resolve this issue.
Instrument cluster periodically failed. No speedo, gas gauge, tach, temp. gauge,etc.(had this same problem with 1995, and 1998 models of chrysler/dodge minivans, the 1999 would 'correct' if I hit the dash board just right, the others would not-I would just drive them without the gauges and eventually they would come back on). This 1999 had anti-theft also, so if instrument cluster was 'out' when trying to start the van, it would not start. I g...
The front legs for the third row bench seat may not retract. Our technicians tells us a new parts kit and/or spring is available to correct this concern.
There have been reports of excess oil consumption due to oil burning in the combustion chamber. This can be occurring even without the traditional blue oil smoke noted from the tail pipe. In some cases this oil consumption is due to problems with the PCV system. It is recommend a complete inspection of the PVC system, including this oil baffle inside the valve cover, be performed if excess oil consumption is noted. According to the manufacturer, usage of 1quart of oil every 1,000 miles is acceptable.
A problem with the sliding door track and door stops can allow the door to slide out of the track and fall off the vehicle. This is more common when doors are opened fast and allowed to hit the stops with a lot of force.
If the heater is on and no heat is felt from the right side dash vents, there may be a problem with the blend air door shaft; a revised part is available to address this concern.
V6 engines may experience surging while driving. The condition is more noticeable between 40 and 50 MPH while accelerating up a hill/slight incline. Replacing the powertrain control module (PCM) and updating the transmission control module (TCM) software may be required.
A "tapping plate cage" on the driver side frame rail may cause a squeak or tick noise while driving, this is often misdiagnosed as a suspension problem. The tapping plate is a threaded plate which accepts one of the front sub-frame mounting bolts. The "cage" of the threaded plate may be touching the frame rail causing noise as the vehicle is driven. "Adjusting" the rear tab on the tapping plate cage so it no longer is touching the frame should eliminate this noise.
Excessive oil consumption—defined as more than one quart per 1,000 miles (on vehicles with less than 50,000 miles) or more than one quart per 750 miles (on vehicles with more than 50,000 miles)—is common. Common causes include exhaust valve guides, valve cover gaskets, camshaft plugs, camshaft seals, and crankshaft seal.