1999 Chrysler Town & Country Questions
All 1999 Chrysler Town & Country Questions
Ask a Question
It happened before but it was one of the big fuses that needed to be replaced. This time it's not that all the fuses are good.it won't at all in all my light's in battery work starter is new in alternator is new
I recently took my 99 Town and Country minivan to get the front break pads and rotor done and also got an oil change. When I got it back, I noticed that the front A/C wasn't working. It's releasing cool air, but not m...
I have a cluster problem how or where do I get a new or rebuilt one. Can I install myself if not where do I go. Sometimes car starts for a few second then quits the gages work and some times don't fuel gage goes up an...
sometimes when start car will only run for a few seconds then shut down. speedometer, gas gauge, oil light work and then don't work this is a constant headache
The icon illuminated briefly, less than 5-seconds, and the alarm sounded. The oil was just above the add mark.
The AC was on. When I checked the coolant it was almost all gone. This car is a 1999 Chrysler Town and Country given to me a family member. I have no ideal if the leaking fluid is coolant.
I can start my van and it runs fine in park and neutral but when I put it in drive it dies...
I changed the radiator and now the heat isn't working anymore and every time I accelerate the fluid leaks out of the bottom
What could be causing this.
since its been so hot,van will start running bad n cut off,we found out to make it run again,is let air out of the valve on the gas line on top of the engine,does anyone know what causes this? and/or how to fix it?it ...
Happens with moisture in the air. After sitting 3 hours, it will stay started fine.
When I'm driving 55 to 60 mph I notice a front end shimmy.
I am not a mac. have worked on old cars but not the newer ones are the lifters easy to change
please give me a godd price.
I know this was a Chrystler recall problem but that has expired my main question is ...do I have to remove injectors to get to the o ring ? if not I can probably fix myself