1995 Chrysler Town & Country Problem Reports

Newest 1995 Chrysler Town & Country Problem Reports

Report A Problem

The speedometer may become inoperative due to a failed vehicle speed sensor (VSS), . A failed sensor will require replacement.

Sometimes the vent windows' latch can pop open; if it will not stay closed or rattles, the latch assembly should be replaced.

A problem with the sliding door track and door stops can allow the door to slide out of the track and fall off the vehicle. This is more common when doors are opened fast and allowed to hit the stops with a lot of force.

A refrigerant leak at the rear AC expansion valve and/or AC evaporator seals may cause the rear AC not to work.

The rear lift gate support (prop) attaching bolts may break, causing the lift gate to fall unexpectedly. Thorough inspection of the bolts is required; if the support washers are loose, the supports need to be replaced.

Excessive oil consumption—defined as more than one quart per 1,000 miles (on vehicles with less than 50,000 miles) or more than one quart per 750 miles (on vehicles with more than 50,000 miles)—is common. Common causes include exhaust valve guides, valve cover gaskets, camshaft plugs, camshaft seals, and crankshaft seal.

Shifting harshness and shuddering issues related to the operation of the automatic transmission have been addressed by factory service bulletins. The shuddering can feel like the vehicle is being driven over rumble strips.

A yellow anti-lock brake system (ABS) warning light may remain illuminated. If a wheel speed sensor fault is discovered, sensor connectors should be inspected. Damaged or spread terminals must be repaired or replaced.

Triggered by a short in the rear wiper motor/circuit (which causes a fuse to blow), the airbag warning light can illuminate erroneously.

The transmission has numerous problems; symptoms can range from shuddering to completely dying. The majority of the TSBs (service bulletins) require an overhaul of the transmission. Updated internal parts are available. 
Carbon buildup on the top of the piston is common. As the buildup increases with mileage and over time, symptoms vary from light ticking, to ticking/hammering, to hammering/knocking noises. Fuel injector cleaner often solves the problem.
An intermittent loss of speed control can happen soon after the transaxle input or output speed sensor has been replaced. The problem is most likely caused by bad connectors.
An improperly-seated connection on the starter (coming from the battery) may cause the engine not to crank. Plastic must be ground off the cable terminal so it can sit flat and flush.
Due to corrosion at the pivot, the driver side window wiper may fail. The pivot must be replaced.
Often caused by rust, the temperature control lever may be difficult to move. Spray an anti-rust penetrate on the lower pivot for the lever and apply lubricant to prevent future corrosion.