1990 Chrysler Town & Country Problems
RepairPal has identified the most common problems with the 1990 Chrysler Town & Country as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Shifting harshness and shuddering issues related to the operation of the automatic transmission have been addressed by factory service bulletins. The shuddering can feel like the vehicle is being driven over rumble strips.
Triggered by a short in the rear wiper motor/circuit (which causes a fuse to blow), the airbag warning light can illuminate erroneously.
Excessive oil consumption—defined as more than one quart per 1,000 miles (on vehicles with less than 50,000 miles) or more than one quart per 750 miles (on vehicles with more than 50,000 miles)—is common. Common causes include exhaust valve guides, valve cover gaskets, camshaft plugs, camshaft seals, and crankshaft seal.
Carbon buildup on the top of the piston is common. Over time this can lead to symptoms varying from light ticking to knocking noises. Performing a fuel injector cleaning procedure can often help the condition by removing some of the piston top deposits.
The rear lift gate support (prop) attaching bolts may break, causing the lift gate to fall unexpectedly. Thorough inspection of the bolts is required; if the support washers are loose, the supports need to be replaced.
The speedometer may become inoperative due to a failed vehicle speed sensor (VSS), . A failed sensor will require replacement.
The door ajar light may illuminate and chime during driving, even when the sliding door is closed. Often, this is caused by a faulty switch in the C-pillar; a revised switch is available.
Sometimes the vent windows' latch can pop open; if it will not stay closed or rattles, the latch assembly should be replaced.
A problem with the sliding door track and door stops can allow the door to slide out of the track and fall off the vehicle. This is more common when doors are opened fast and allowed to hit the stops with a lot of force.
An intermittent loss of speed control can happen soon after the transaxle input or output speed sensor has been replaced. The problem is most likely caused by bad connectors.
Voltage spikes can cause erratic behavior in the electrical system (lights, locks, wipers, head lamps). This is often caused by relays. Inspection and replacement of relays is required; revised relays are available.
The airbag warning light may remain illuminated while the ignition switch is in the "on" position. This can be caused by water that has entered into the airbag six-way connector in the engine compartment.