2006 Chrysler Sebring Problems
RepairPal has identified the most common problems with the 2006 Chrysler Sebring based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The blend door actuator for the HVAC system may fail causing a continuous loud clicking noise when cycling the recirculation button, or switching from heat to air conditioning. Replacement of the actuator is required to remedy the issue.
The automatic transmission can develop problems like erratic shifting, rough shifting, or delayed gear engagement. Repairs for many of these problems are outlined in service bulletins.
There have been reports of premature head gasket failure; an updated gasket design is available to correct this problem.
Sensor failure inside the distributor can cause intermittent stalling or a failure to start. In addition, the wires to the distributor are susceptible to internal damage, which can cause the same symptoms.
A rattle from the rear of the vehicle may indicate that the rear shock absorbers are defective. Updated shocks are available; however, careful inspection of all suspension components should be performed before any parts are replaced.
Due to a problem with the rear drain, the sunroof may develop a leak into the passenger area. The drain tube can get kinked; tubing can be installed over the drain hose to prevent further problems.
A plugged AC evaporator drain tube can cause a water leak inside the car; usually near the front passenger's feet.
For the sedan trim only, Coolant can leak at the coolant bleeder valve and is usually evident because of an orange crust formation on the housing. A revised bleeder and housing is available to correct this problem.