2001 Chrysler Sebring Problem Reports

Newest 2001 Chrysler Sebring Problem Reports

Report A Problem

A rattle from the rear of the vehicle may indicate that the rear shock absorbers are defective. Updated shocks are available; however, careful inspection of all suspension components should be performed before any parts are replaced.

Just the dash lights went out about a month ago.

Convertible model
One or both windshield washer nozzles may plug or clog. There are revised washer nozzles available which are more resistant to plugging.

For the sedan trim only, Coolant can leak at the coolant bleeder valve and is usually evident because of an orange crust formation on the housing. A revised bleeder and housing is available to correct this problem.

3.0L V6 (coupe)
Erroneous Check Engine Light illumination for intermittent misfires can be solved with a software update to the powertrain control module (PCM).

There have been reports of premature head gasket failure; an updated gasket design is available to correct this problem.

Sedan and Convertible
If you hear a honk or "fog horn" sound within a few seconds of turning on the air conditioning, that can be fixed by replacing the AC expansion valve. Occasionally vibration from the honking can be felt in the steering wheel and car seats.

Sedan and Convertible
A click heard when turning the steering wheel may be solved by aligning the steering column or installing revised steering column parts as necessary. Installing the revised parts will require removal of the steering column from the vehicle.

A plugged AC evaporator drain tube can cause a water leak inside the car; usually near the front passenger's feet.

Sensor failure inside the distributor can cause intermittent stalling or a failure to start. In addition, the wires to the distributor are susceptible to internal damage, which can cause the same symptoms.

A defective vehicle speed sensor can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors are also susceptible to corrosion, which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.

An engine Oil leak may develop at the cam sensor o-ring seal. Our technicians tell us this is often misdiagnosed as an external head gasket leak.

It is important to use the correct oil filter in the 4 cylinder engine. There are two different 2.4L engines, which use different filters. The 2.4L in the coupe is made by Mitsubishi motors while the 2.4L in the sedan is made by Chrysler. Using the incorrect filter can result in engine damage as a result of oil loss.


The Check Engine Light may illuminate with codes P0440 or P0457. Our technicians tell us that replacing the evaporative system integrity module (ESIM) filter and the ESIM as necessary should correct this issue.

Foam tape placed between the door trim panel and door sheet metal can solve a rattling issue caused by audio output from the door speakers.