Software updates are available to address transmission issues. However, due to the age of these vehicles, mechanical failures are more likely to be causing transmission problems. If a mechanical failure is repaired or the transmission is replaced, it is important to make sure any software updates have been taken care of. Failure to do so could result in continuing transmission issues.
Problems for specific Chrysler Sebring years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1998 Chrysler Sebring problems
There have been reports of premature head gasket failure; an updated gasket design is available to correct this problem.
The carpet under the right side of the dash may become wet with water. This can be caused by the AC evaporator drain being plugged with debris. Our technicians tell us that once the drain is clear, a cabin air filter should be installed to keep debris out.
Failure to use the correct automatic transmission fluid and follow the maintenance schedule can result in shifting problems.
Spark plug tube seals fail, causing the tubes to fill with engine oil and the engine to misfire. As a result, the engine may run poorly and fuel economy can suffer.
Sensor failure inside the distributor can cause intermittent stalling or a failure to start. In addition, the wires to the distributor are susceptible to internal damage, which can cause the same symptoms.
A defective vehicle speed sensor can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors are also susceptible to corrosion, which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.
The automatic transmission can develop problems like erratic shifting, rough shifting, or delayed gear engagement. Repairs for many of these problems are outlined in service bulletins.
Corrosion on the door ajar switch can cause the door ajar warning light and dome light to work intermittently or not at all. A new switch (and possibly a new connector) will be needed to fix the issue.