Problems for specific Chrysler Sebring years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 1997 Chrysler Sebring problems
A defective EGR valve can cause a popping or knocking noise from the engine compartment. It is usually heard when the engine is warm (between 1600 and 1800 RPM).
Software updates are available to address transmission issues. However, due to the age of these vehicles, mechanical failures are more likely to be causing transmission problems. If a mechanical failure is repaired or the transmission is replaced, it is important to make sure any software updates have been taken care of. Failure to do so could result in continuing transmission issues.
There have been reports of premature head gasket failure; an updated gasket design is available to correct this problem.
Clogged drains can cause many problems with the sun roof. To prevent water damage related problems, the sun roof and its drains should be clear of leaves and dirt. The sun roof may also stick or bind for other reasons. There are service bulletins that address many of these concerns.
A plugged AC evaporator drain tube can cause a water leak inside the car; usually near the front passenger's feet.
Failure to use the correct automatic transmission fluid and follow the maintenance schedule can result in shifting problems.
Sensor failure inside the distributor can cause intermittent stalling or a failure to start. In addition, the wires to the distributor are susceptible to internal damage, which can cause the same symptoms.
A defective vehicle speed sensor can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors are also susceptible to corrosion, which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.
The automatic transmission can develop problems like erratic shifting, rough shifting, or delayed gear engagement. Repairs for many of these problems are outlined in service bulletins.
Corrosion on the door ajar switch can cause the door ajar warning light and dome light to work intermittently or not at all. A new switch (and possibly a new connector) will be needed to fix the issue.
The front door may make a rattling or fluttering sound when closing the door with the window down. Our technicians tell us the outer belt molding may be causing the noise and if so in should be replaced with an update part.