» » »

Problems for specific Chrysler Pacifica years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Most reported 2007 Chrysler Pacifica problems

 

Verified for the Chrysler Pacifica

The engine may develop a ticking noise, often caused by a broken retaining pin on the rocker arm shaft. When the pin breaks, the shaft can spin blocking the oil passage the rocker arms (which causes the ticking noise). The rocker arm shafts, rocker arms, and pedestals (sold as a kit) are commonly replaced in order to correct this condition.

83 Reports
Me Too

Verified for the Chrysler Pacifica

Static discharge and/or loose wire connections could cause problems with the front power seat memory, seat heaters, and adjustable pedals. Revised seat modules are available that resist the affects of static discharge.

22 Reports
Me Too

Verified for the Chrysler Pacifica

If the HVAC (heater) housing is not properly sealed at the bulkhead (firewall), water can leak into the passenger compartment. Foam sealant should be used to seal any gaps and the evaporator drain tube can be modified to prevent further water entry.

10 Reports
Me Too

Verified for the Chrysler Pacifica

Static discharge through the right (passenger) front door handle can result in a loss of functionality from the right front door switches, power mirrors, seat controls, and door locks. There is a revised door handle which is more static resistant. A new door module may be needed if the module does not reset properly.

10 Reports
Me Too

Verified for the Chrysler Pacifica
If the cup holder lid will not stay closed, a lid spring was released so replacing the entire assembly should not be necessary.
8 Reports
Me Too

Verified for the Chrysler Pacifica

"False" trouble codes may cause erroneous illumination of the Check Engine Light. Updating the PCM software can often correct this concern.

7 Reports
Me Too

Verified for the Chrysler Pacifica
If the moon roof makes a thumping noise moving from the closed to the vent position, using some lubricant (available from Dodge) on the moon roof seal can solve the problem.
3 Reports
Me Too
Ask a Question