» » »

Problems for specific Chrysler Concorde years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Repairpal verified 1996 Chrysler Concorde problems

 

Verified for the Chrysler Concorde

A defective fuel pump check valve (which maintains fuel pressure in the system when the vehicle is not running) may lead to long cranking times or hard starting (sometimes with stalling). The fuel pump should be replaced. However, if these symptoms are accompanied by Check Engine Light illumination, there may be a problem with the engine coolant temperature (ECT) sensor.

3 Reports
Me Too

Verified for the Chrysler Concorde

Debris and corrosion in the AC housing may cause the AC evaporator core to develop a refrigerant leak.

6 Reports
Me Too

Verified for the Chrysler Concorde

The window glass lift plates tend to bend or break and cause the window glass to tilt and bind in the door. The lift plates can be replaced separately from the window regulator. In more severe cases, however, a new window regulator may also require replacement.

27 Reports
Me Too

Verified for the Chrysler Concorde

Worn sway bar bushings or sway bar end links may cause a rattling or clunking noise from the front suspension during low-speed driving. Though not always the root cause, front struts are often replaced for this condition.

33 Reports
Me Too

Verified for the Chrysler Concorde

The fuel level sensors can wear out and cause erratic or inaccurate fuel gauge readings.

4 Reports
Me Too

Verified for the Chrysler Concorde

Software updates are available to address transmission issues. However, due to the age of these vehicles, mechanical failures are more likely to be causing transmission problems. If a mechanical failure is repaired or the transmission is replaced, it is important to make sure any software updates have been taken care of. Failure to do so could result in continuing transmission issues.

9 Reports
Me Too

Verified for the Chrysler Concorde

On higher-mileage vehicles, engine oil leaks from the valve covers and front crankshaft seal are common.

11 Reports
Me Too

Verified for the Chrysler Concorde

Faulty pressure transducers (sensors) or the evaporator temperature sensor may cause the AC to stop functioning. The body control module (BCM) may lock up and create similar symptoms. Disconnect the battery for five seconds before resetting the BCM.

5 Reports
Me Too

Verified for the Chrysler Concorde

Some vehicles may develop a musty odor coming from the HVAC system, Dodge has issued a cleaner/disinfectant and a coating for the evaporator designed to inhibit bacterial growth.

20 Reports
Me Too

Verified for the Chrysler Concorde

A worn AC belt idler pulley may cause the AC belt to roll over in the pulleys or come off completely.

6 Reports
Me Too

Verified for the Chrysler Concorde

Timing cover oil and coolant leaks are common, the oil and coolant don't normally mix. Our technicians recommend to replace the timing chain and cam sprocket if the timing cover is removed to reseal - or for any other reason.

4 Reports
Me Too

Verified for the Chrysler Concorde

The automatic transmission can develop problems like harsh shifting, shuddering between shifts, and a buzzing while in Reverse. Repairs for many of these problems are outlined in service bulletins and require removal and disassembly of the transmission.

6 Reports
Me Too

Verified for the Chrysler Concorde

When a no start condition is caused by a faulty camshaft or crankshaft sensor, related fault codes stored in the powertrain control module (PCM) should not be trusted. Our technicians tell us that under certain conditions a fault code can be stored for the "good" sensor. Care should be taken to properly diagnose this condition.

20 Reports
Me Too

Verified for the Chrysler Concorde

Failure to use the correct automatic transmission fluid and follow the maintenance schedule can result in shifting problems.

7 Reports
Me Too

Verified for the Chrysler Concorde

Poor output from the heater and/or engine overheating can be caused by air left in the cooling system after the cooling system has been serviced. Our technicians tell us the proper coolant fill procedure should be used to prevent this problem from occurring.

17 Reports
Me Too
Ask a Question