X

Chevrolet Venture Recalls

RepairPal Expert Overview:

Due to variations in the manufacturing process, or exposure to high heat may lead to a fracture in the tank inlet check valve. Fuel vapors may pass through the fracture and accumulate on the side of the fuel tank. A fuel leak in the presence of an ignition source could result in a fire. Dealers will replace the fuel tank. The recall began December 4, 2007. The GM recall number is 06230.

Models : Chevrolet Venture, Oldsmobile Silhouette, Pontiac Montana, Pontiac Trans Sport
Body, Interior & Misc., May 31, 2005
Summary:ON CERTAIN MINIVANS EQUIPPED WITH SECOND-ROW BUCKET SEATS OR CAPTAIN'S CHAIRS AND A POWER SLIDING DOOR ON THE PASSENGER SIDE OF THE VEHICLE, A PASSENGER USING THE INTERIOR HANDLE TO OPEN THE POWER SLIDING DOOR COULD BE INJURED.
Models : Chevrolet Venture, Pontiac Montana
Body, Interior & Misc., July 23, 2004
RepairPal Expert Overview:

Some minivans are missing the required labels on the second row seating for the integral child restraint system. This is against the Federal Motor Vehicle Safety Standard. Vehicle owners were sent the correct labels with instructions on how to install them. The recall began July 23, 2004. The GM recall number 04022.

RepairPal Expert Overview:

The owner's manual does not explain the child restraint anchor location symbols for the lower universal anchorage system. This does not meet the Federal Motor Vehicle Safety Standard. Owners were sent supplements to the owner's manual explaining the location symbols in the vehicle. The recall began August 18, 2003. The GM recall number is 03039.

RepairPal Expert Overview:

On 130 vehicles, the driver's air bag may not deploy properly if needed in a crash. Also, the inflator could rupture. This could increase the risk of injury to the driver and other passengers if pieces of the inflator strike them. Dealers will inspect and install a new driver's air bag if needed. The recall began March 11, 2003. The GM recall number is 03008.

Summary:CERTAIN PASSENGER VEHICLES AND MINI VANS HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE AND SOME OTHER RETAINERS USED IN VEHICLES ASSEMBLED BETWEEN JANUARY 1, 1996 AND OCTOBER 31, 1997, COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.
Summary:ON CERTAIN PASSENGER, SPORT UTILITY VEHICLES AND MINI VANS, SOME OF THESE VEHICLES HAVE A PASSENGER AIR BAG THAT WAS MANUFACTURED WITHOUT A CHECK VALVE PIN. AN AIR BAG WITHOUT THE CHECK VALVE PIN COULD PRODUCE INCREASED PRESSURE AT THE ONSET OF THE AIR BAG DEPLOYMENT AND REDUCED PRESSURE AFTERWARD.
Summary:CERTAIN PASSENGER, MINI VANS, AND SPORT UTILITY VEHICLES HAVE AN AIR BAG INFLATOR ON THE DRIVER'S SIDE THAT COULD FRACTURE AT A WELD DURING A DEPLOYMENT.
Models : Chevrolet Venture, Oldsmobile Silhouette, Pontiac Aztek, Pontiac Montana
Body, Interior & Misc., April 10, 2002
Summary:VEHICLE DESCRIPTION: CERTAIN MINI VANS BUILT WITH SECOND ROW 50/50 SPLIT BENCH SEATS OR CAPTAIN'S CHAIRS, FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEMS." THE SEAT LATCH ANCHOR WIRE DIAMETER IS GREATER THAN 6.1 MM.
Models : Chevrolet Venture, Oldsmobile Silhouette, Pontiac Montana, Pontiac Trans Sport
Body, Interior & Misc., October 22, 2001
Summary:VEHICLE DESCRIPTION: 1997-2001 CHEVROLET VENTURE, PONTIAC MONTANA/TRANSPORT, AND OLDSMOBILE SILHOUETTE MINI VANS EQUIPPED WITH PASSENGER SIDE POWER SLIDING DOORS THAT WERE SERVICED IN CAMPAIGN 01013 (01V-067) FROM APRIL TO AUGUST 2001. ALSO 2001 CHEVROLET VENTURE, PONTIAC MONTANA, AND OLDSMOBILE SILHOUETTE MINI VANS EQUIPPED WITH PASSENGER SIDE POWER SLIDING DOORS ASSEMBLED IN JANUARY THROUGH APRIL 2001. THESE VEHICLES HAVE INADEQUATE FRONT WELDS. IF A FRONT WELD FAILS, THE ACTUATOR CAN JAM IN THE UNLATCHED POSITION AND, WHEN THE SLIDING DOOR CLOSES, IT WILL NOT BE LATCHED.