The second row center seat belt routing may make it difficult to position correctly on smaller passengers. If the seat belt rides up to fit around the abdomen, the risk of internal injury is increased in a crash. Dealers will cut the guide loop, remove a portion of the loop, and the remaining sides should be folded over and secured with a retainer. The recall began July 21, 2005. The GM recall number is 05037.
Chevrolet Tahoe Recalls
707 vehicles may have a missing brake pedal push rod retainer. If the retainer is missing, the brake pedal could disengage from the booster push rod. This could result in loss of braking ability, increasing the risk of a crash. Dealers will inspect the affected vehicles and install a push rod retainer if necessary. General Motors will begin contacting owners by telephone on March 10, 2005. The General Motors recall number is 05039.
Under certain conditions, the shift lever position indicator located in the instrument cluster may not illuminate. If the indicator does not illuminate, the driver may not know which gear the vehicle is in. This could result in the vehicle moving in an unintended direction, increasing the risk of a crash. Dealers will reprogram the instrument panel cluster to correct this concern. This recall is expected to begin on February 14, 2005. The General Motors recall number is 05023.
The hydro-boost housing relief valve bore may be out of specification. The seal may fracture as a result, which may reduce braking assist and slightly increase the steering effort while braking. Under certain conditions, more braking effort will be required to stop the vehicle. Dealers will replace the hydro-boost relief valve. The recall began June 18, 2004. The GM recall number is 04004.
The courtesy lamps on affected running boards may overheat when exposed to moisture and road salt. Overheating may cause the lamps and boards to melt or start a fire. Dealers will replace the wiring harness for these running boards.
On 107 vehicles, one or two welds on the rear door upper hinge may not be to specification. This may cause the door strength to be reduced in a side impact crash. Dealers will inspect the welds and install a bolt to secure the hinge if any are found to be out of specification.
Two potential pinch points exist on the second row seats when the head restraints are folded rearward and the seat back is folded down. If a person were to insert their finger(s) into the pinch point, it could trap and pinch the finger(s) causing injury. Dealers will install protective covers over the pinch points. The recall began November 22, 2002.
The air bag diagnostic module may contain a flaw that will prevent deployment of the air bags during a collision. This may result in severe injuries sustained by occupants during a collision. Dealers will recalibrate this module to correct the flaw.