Chevrolet Recalls

Summary:
THE MANUFACTURER'S CERTIFICATION LABEL AND/OR THE DRIVER AIR BAG ADVISORY LABEL MAY BE MISSING FROM THE VEHICLES, WHICH DOES NOT CONFORM TO THE REQUIREMENTS OF 49 CFR 567.
Summary:
CRACKS DEVELOP IN THE WHEEL MOUNTING SURFACE. IF THESE CRACKS BECOME SEVERE ENOUGH, THE WHEEL WILL COMPLETELY SEPARATE FROM THE VEHICLE.
Summary:
THESE VEHICLES WERE EQUIPPED WITH INCORRECT SPARE WHEELS. THE USE OF AN INCORRECT SPARE WHEEL IN A MOUNTED POSITION CAN, UNDER CERTAIN LOAD CONDITIONS, EVENTUALLY CAUSE THE WHEEL TO CRACK AND POSSIBLY SEPARATE FROM THE VEHICLE.
Summary:
PAINT ON THE WHEEL MOUNTING SURFACES CAN ACT AS A SHIM BETWEEN THE WHEEL AND THE ROTOR/DRUM. AS THE VEHICLE IS DRIVEN, THE WHEEL IMBEDS INTO THE PAINT, LOOSENING THE LUG NUT AND CAUSING A LOSS OF CLAMP LOAD.
Summary:
THE ENGINE OIL COOLER INLET HOSE MAY HAVE BEEN INSTALLED TOO CLOSE TO THE STEERING GEAR CAUSING CHAFING. THE CHAFING CAN EVENTUALLY WEAR THROUGH THE HOSE'S PROTECTIVE SLEEVE RESULTING IN ENGINE OIL LEAKING ONTO THE ENGINE.
Summary:
VEHICLE FAILS TO CONFORM TO FMVSS NO. 209, "SEAT BELT ASSEMBLIES." THE SAFETY BELT OF THE LEFT THIRD ROW SEAT ON THE SIX PASSENGER VAN AND THE CENTER SECOND ROW SEAT OF THE SEVEN PASSENGER VAN MAY LOCK UP AND CANNOT BE WITHDRAWN FROM THE RETRACTOR.
Summary:
THE THIRD ROW SAFETY BELT RETRACTORS MAY BE INSTALLED INCORRECTLY AND MAY LOCK-UP WHEN THE VEHICLE IS ON SLOPES OF LESS THAN 15 DEGREES, WHICH DOES NOT COMPLY WITH FMVSS NO. 209, "SEAT BELT ASSEMBLIES."
Summary:
THE FUEL TANK FILLER PIPES WERE NOT MANUFACTURED TO SPECIFICATION WHICH CAUSED LOSS OF FUEL BETWEEN THE FUEL TANK FILLER PIPE AND THE VENT TUBE DURING A TEST. THE LOSS OF FUEL WAS IN EXCESS OF THE AMOUNT PERMITTED BY FMVSS NO. 301, "FUEL SYSTEM INTEGRITY."
Summary:
THE RECLINER MECHANISM AND THE SEAT FRAME MAY HAVE FOAM AND/OR VINYL BETWEEN THEM, CREATING A "SOFT" JOINT. THIS "SOFT" JOINT RESULTS IN LOWER THAN SPECIFIED BOLT TORQUE WHICH LEADS TO JOINT LOOSENESS, CAUSING BOLT FATIGUE AND EVENTUAL BOLT FAILURE.
Summary:
THE SAFETY BELT RETRACTORS FOR THE REAR CENTER POSITION ARE MISSING A PAWL SPRING AND IN CASE OF AN ACCIDENT, WILL ALLOW THE SAFETY BELT WEBBING TO EXTEND BEYOND THE MINIMUM REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."