X

Chevrolet Colorado Recalls

Models : Chevrolet Colorado, GMC Canyon
Body, Interior & Misc., December 19, 2012
RepairPal Expert Overview:

The front hood is secured by two latches, the primary and secondary latch. The secondary latch prevents the hood from opening when the primary latch has been activated. These vehicles are being recalled because some may have been assembled without a secondary hood latch. With this latch missing, if the primary latch is not properly engaged the hood could open unexpectedly while driving. This could obstruct the view of the driver, increasing the risk of a crash. Dealers will replace the hood on the affected vehicles to correct this concern. 

Models : Chevrolet Colorado, GMC Canyon
Body, Interior & Misc., November 17, 2011
RepairPal Expert Overview:

Certain vehicles may have been produced with a driver's side seat belt buckle electrical connector that does not fit snugly with the connector terminals, causing the electrical connection to be intermittent. This loose electrical connection may cause the driver not to receive a visual or audible warning that the driver's seat belt is not fastened. If the seat belt is not properly fastened in the event of a crash, there is an increased risk of personal injury. Dealers will replace the seat belt buckle electrical connector terminals to correct this concern. The General Motors recall number is 11322.

Models : Chevrolet Colorado, GMC Canyon
Drive Train, June 28, 2011
RepairPal Expert Overview:

Certain vehicles may have been assembled with an automatic transmission shift cable adjustment clip that may not retain the cable in the correct position. If the cable is not properly retained, the shift indicator may not show the correct transmission gear. The driver could move the shifter to "Park" and remove the ignition key, but the transmission gear may not be in "Park." The driver may not be able to restart the vehicle and the vehicle could roll unexpectedly, increasing the risk of a crash or personal injury. Dealers will install a new automatic transmission adjustment clip to correct this concern. This recall is expected to begin on July 19, 2011. The General Motors recall number is 11181.

Models : Chevrolet Colorado, GMC Canyon
Body, Interior & Misc., May 5, 2011
RepairPal Expert Overview:

The windshield wiper motor crank arm nut may not be tightened to specification. If the wipers are operated with a buildup of snow or ice, or when the windshield is dry, the crank arm nut could loosen to the point where the wipers become inoperative. This could reduce driver visibility, increasing the risk of a crash. Dealers will secure the crank arm nut to correct this concern. This recall is expected to begin by May 11, 2011. The General Motors recall number is 11095.

RepairPal Expert Overview:

The rear axle cross pin may break. The cross pin is an internal component of the rear differential, which is housed in the rear axle assembly. If the cross pin breaks, the rear axle may lock, which could result in loss of control and a crash. Dealers will install a new rear axle cross pin to correct this concern. This recall should begin no later than January 25, 2011. The General Motors number for this recall is 10426A.

RepairPal Expert Overview:

General Motors is recalling certain 2004–2011 Chevrolet Colorado, GMC Canyon, and Isuzu regular and extended cab models without a rear seat and equipped with a 60/40 front bench split seat for failing to comply with federal safety standards on child restraint anchorage systems. The top tether anchor for the front center seat is not accessible and the manual provides no instruction on its use. In order to correct the problem, dealers will cut a hole in the back panel trim cover to allow access to the top tether anchor and will provide supplemental instructions on the use of the top tether.

RepairPal Expert Overview:

General Motors is recalling various 2004–2009 models in twelve Southern and Southwestern states, Puerto Rico, and the U.S. Virgin Islands due to contamination in the brake lamp switch, which may cause the brake lamps to fail or stay on continuously. This could lead to a crash since other drivers may not be aware of the operator's intentions. Dealers will inspect and replace the necessary components free of charge. For more information, call Chevrolet at 1-800-630-2438, GMC at 1-866-996-9463, or Isuzu at 1-800-255-6727.

RepairPal Expert Overview:

The RTV seal on the fuel system control modules may allow water to enter into the module. Water in the module can cause a short, which may cause hard starting, a crank-no start condition, or stalling, and the Service Engine Soon light may come on. If the engine stalls unexpectedly, there is an increased risk of a crash. Dealers will replace the fuel system control module free of charge. The recall began on May 18, 2009. The GM recall number is 08411.

Models : Chevrolet Colorado, GMC Canyon
Electrical & Lights, December 5, 2006
RepairPal Expert Overview:

The brake lights may fail to illuminate, or illuminate at all times. In this condition, the cruise control will not function. If towing a trailer connected to the brake lamp wiring, the trailer lights will also be affected. A following driver may not know when the brakes are applied, increasing the risk of a rear-end crash. Dealers will replace the brake lamp switch assembly. The recall began December 5, 2006. The GM recall number is 06030.

RepairPal Expert Overview:

The tire and loading information label on the driver's side door frame may be inaccurate. A misprinted label could lead to overloading of the vehicle, which could possibly lead to tire failure and a crash. Owners will be provided with corrected labels and installation instructions. At customers' request, a dealer can install the label for them. The recall began March 31, 2006. The GM recall number is 05109.