2006 Chevrolet Uplander Problem Reports

Most Reported 2006 Chevrolet Uplander Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

Front brake rotors can wear causing a pulsation felt in the brake pedal. Our technicians often recommend replacement of the front rotors and brake pads as the best option to correct this condition.

The high pressure power steering hose will commonly leak fluid and should be replaced if this is the case.

The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.

Corrosion at the fuel tank to body harness may cause the Check Engine Light to illuminate or a crank no start condition. This corrosion issue is most commonly caused by a water leak inside the vehicle. Any damaged wiring or connectors will require replacement.

All of the sudden stopped working

One or more of the power windows may stop working due to a failed window switch. Failed switches will require replacement.

Had to pump gas when starting. A bottle of Crc throttle body and intake cleaner, a bottle of Crc mass air flow sensor cleaner and a tooth brush fixed the problem. Less than a $20 fix and a hour of time. Disconnect the battery, remove Maf sensor and spray thoroughly on both sides of sensor, allow time to dry completely. For throttle body take off air flow tube and prop open throttle blade spray and scrub thoroughly, wipe clean, spray in all po...