2007 Chevrolet Tahoe Problems
RepairPal has identified the most common problems with the 2007 Chevrolet Tahoe as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The power door lock actuators may become slow to operate or stop working completely and require replacement.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault. The warranty has been extended on some of these units to 7 years or 70,000 miles.
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
The front or rear differential may develop an abnormal noise due to worn bearings or another internal fault. Our technicians tell us that a complete overhaul of the affected differential is commonly necessary to correct this condition.
The upper dash may crack, most commonly on vehicles in warm climates and exposed to a lot of sunlight. The common repair is to replace the upper instrument trim panel. Information on a technical service bulletin or extended warranty is not available at this time.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
The inside and outside door handles are prone to breaking.
The rear window defogger may stop working due to a wire terminal broken off of the rear glass. Our technicians tell us that terminal can be reattached using a special glue or silver solder.
The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 2000-2003 models is #4114K (trade number).
One or more fuel injectors may become stuck closed causing an engine misfire and the Check Engine Light to illuminate. Our technicians tell us that this problem can be caused by some fuel additives. There are special procedures which may be able to restore the affected injector. If this fails the affected injector must be replaced.
The inside door handles are prone to breaking.
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.