1999 Chevrolet Suburban 2500 Problems
RepairPal has identified the most common problems with the 1999 Chevrolet Suburban 2500 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Power brake systems using "hydro-boost" may leak power steering fluid from the hydro-boost unit located behind the brake master cylinder. Replacement of the hydro-boost unit is the common repair to correct this concern.
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.
The engine may develop a misfire due to worn valve seats. This fault will cause the Check Engine Light to illuminate. Our technicians tell us the misfire may or may not be felt while driving. They further recommend that both cylinder heads be removed and thoroughly inspected and repaired as necessary.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
One or more fuel injectors may become stuck closed causing an engine misfire and the Check Engine Light to illuminate. Our technicians tell us that this problem can be caused by some fuel additives. There are special procedures which may be able to restore the affected injector. If this fails the affected injector must be replaced.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
The alternator may fail causing the battery to go dead, or an abnormal noise may develop. The dash warning light may or may not illuminate. A failed alternator will require replacement.
The quick-connect fittings for the heater hoses tend to leak engine coolant. This problem commonly occurs because the metal housing has become brittle, which can break and cause leaks.
The air conditioning compressor may develop an abnormal noise and require replacement. Our technicians tell us that whenever a compressor is being replaced for a noise condition, a filter kit should be installed to prevent any metal particles in the system from damaging the new compressor.