» » »

Car Recalls

Recalls are issued for cars with safety-related defects or problems

2003 Chevrolet Suburban 1500 recalls

 

Body, Interior & Misc., July 21, 2005

RepairPal Expert Overview:

The second row center seat belt routing may make it difficult to position correctly on smaller passengers. If the seat belt rides up to fit around the abdomen, the risk of internal injury is increased in a crash. Dealers will cut the guide loop, remove a portion of the loop, and the remaining sides should be folded over and secured with a retainer. The recall began July 21, 2005. The GM recall number is 05037.

Learn more »

Brakes, June 18, 2004

RepairPal Expert Overview:

The hydro-boost housing relief valve bore may be out of specification. The seal may fracture as a result, which may reduce braking assist and slightly increase the steering effort while braking. Under certain conditions, more braking effort will be required to stop the vehicle. Dealers will replace the hydro-boost relief valve. The recall began June 18, 2004. The GM recall number is 04004.

Learn more »

Body, Interior & Misc., March 7, 2003

RepairPal Expert Overview:

The courtesy lamps on affected running boards may overheat when exposed to moisture and road salt. Overheating may cause the lamps and boards to melt or start a fire. Dealers will replace the wiring harness for these running boards.

Learn more »

Engine, February 20, 2003

RepairPal Expert Overview:

In 30 degree left angle frontal crash conditions with a severe enough impact, the fuel tank may be punctured by a torn mid-frame cross member. A fuel leak in the presence of an ignition source may result in a fire. Dealers will install a fuel tank shield. The recall began February 20, 2003. The GM recall number is 03002.

Learn more »

Body, Interior & Misc., February 17, 2003

RepairPal Expert Overview:

On 107 vehicles, one or two welds on the rear door upper hinge may not be to specification. This may cause the door strength to be reduced in a side impact crash. Dealers will inspect the welds and install a bolt to secure the hinge if any are found to be out of specification.

Learn more »