2005 Chevrolet Silverado 1500 HD Problems

RepairPal has identified the most common problems with the 2005 Chevrolet Silverado 1500 HD as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
18
Known Problems

The headlight switch used on the Chevrolet Silverado 1500HD and 2500HD is known to fail through normal operation. Since the headlight switch is also integrated into the interior lights, a malfunctioning switch can cause issues with interior lights as well.

  • Symptoms of a failed headlight switch include:
  • Headlights and taillights failing to turn on or off
  • Interior lights flicker, or fail to turn on or off
  • Gauge cluster lighting off or flickering with headlights on
  • Parking light malfunctions  

This issue is well known with General Motors Trucks and SUVs, and is solved by testing and, if needed, replacing the headlight/dimmer switch. Bad grounding wires at the tail-lights, and dirty/corroded tow package wires can also lead to some of these issues. 

The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.

The steering wheel position sensor may fail, resulting in the service stability message being displayed.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.

The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault. The warranty has been extended on some of these units to 7 years or 70,000 miles.

The steering may develop a clunk type noise from the upper intermediate steering shaft.  Our technicians tell us that you should check with you local GM dealer to find out what the latest repair is for this condition.

A dirty throttle body may cause a lower than normal idle and possible stalling condition. Performing a throttle body service will commonly correct this concern.

The muffler heat shield may become loose on the muffler causing a rattle or popping noise. Our technicians tell us there is a kit available from GM to correct this problem.

A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.

One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.

Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.
Our technicians highly recommend that the transmission is serviced every 30,000 miles to avoid problems and maintain optimal operating order.

Our technicians recommend flushing the brake fluid every 60,000 miles.  Brake fluid that is dirty may cause problems in the brake system.

Fuel pump failures are common on higher mileage models, Resulting in a crank no start condition.