2002 Chevrolet Silverado 1500 Questions

Unanswered 2002 Chevrolet Silverado 1500 Questions

Ask a Question
View:RecentAnsweredUnanswered
Truck over heats at stops unless I rev the motor. Not every stop though. Plus the truck has close to 300,000mi.Engine is still strong and I have changed the oil regularly with full synthetic. I am the original owner.
On my 2002 chevy Silverado there is a lot of rattling on the front end and felt through steering around turns. Already replaced some stuff up there,center link,inner outer tyrod end,hub asembally. Not sure what it cou...
Dealer said I need a new encoder motor but can't be sure, it would cost around $1000.00 are there other parts causing this problem or does this sound right?
at first i could jus turn it off then right back on and it would be fine but now its sputtering and no acceleration when pressing gas pedal.
The turn signals are lit up on the dash but they are not actually on but when I do go to use them there is nothing. It used to be the lights would flick on and off for the first thirty seconds of driving and then fina...
I've testedvthis with a modis scantool and have been told by the dtc charts that I should replace the ebcm and pump. Is there anything else I can do before I put a new ine in? I was using alldata.com to get info. Also...
the truck will restart while driving but if stopped you have to use the key to resart.
After the fog lights were installed and the computer programmed for the addition the daytime running lights will not come on. Dealer has had all sorts of excuses but no fixes.
i put my truck in reverse did not wait until the rpms came down right away and dropped it into drive i then heard a loud thud like i hit something then the truck started making a noise stopped put it in park it then s...
What does it mean to have a short in the computer?
started out only going out when in one specific position. then i would have to hold the tilt button in the unlock position and slamming the wheel into the lowest position lights worked for about 2 blocks and won't com...
it sounds like its gonna start then just wont turn over, all electrical systems seem fine from cab