Problem Reports
Problem with your car? See what our experts say or submit your own.
2000 Chevrolet Silverado 1500 Problems
Steering May Develop Clunk Noise From Upper Intermediate Steering Shaft
The steering may develop a clunk type noise from the upper intermediate steering shaft. Our technicians tell us that you should check with you local GM dealer to find out what the latest repair is for this condition.
Service 4WD Message May be Displayed
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
Erratic Fuel Gauge Operation
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
Daytime Running Lights Are Prone to Burning Out
The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 1999-2003 models is #4114K (trade number).
Improper HVAC Temperature and/or Air Delivery Due to Failed Mode Door Actuator
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
Check Engine Light Due to Restricted Secondary Air Injection Check Valve
One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.
ABS Light Due to Poor Electrical Ground Under the Battery Tray
A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.
Parking Brake Does Not Hold Due to Worn Parking Brake Shoes
Units with 4 wheel disk brakes may develop at situation where the park brake does not hold as it should. Our technicians tell us this can be caused by worn park brake shoes located inside the drum section of the rear brake disks. The worn shoes should be replaced and properly adjusted to correct this issue.
Popping Noise From Muffler Heat Shield
The muffler heat shield may become loose on the muffler causing a rattle or popping noise. Our technicians tell us there is a kit available from GM to correct this problem.
Clicking Noise From Flasher When Turn Signals are Off
A clicking noise may be noted from the turn signal flasher after the turn signals are switched off. This is commonly cause by a faulty turn signal switch which will require replacement.
CD Player May Fail Due to Internal Fault in Radio
The CD player may fail due to an internal fault with the radio. Our technicians tell us that in most cases, the radio unit will need to be sent to a specialty repair shop to correct this issue.
Dead Battery Due to ABS Pump Not Turning Off
The anti-lock brake system (ABS) pump may stay running after the ignition is turned off causing the battery to go dead. Our technicians tell us that the ABS control module should be replaced to correct this fault.
The Fuel Pump May Fail Causing the Engine to Stall or Crank Over But Not Start
The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
Corrosion on Battery Cable Ends
Acid may leak from the battery at the cable connections, resulting in corrosion on the battery cable ends and in the battery tray. A Leaking battery should be replaced and the cables thoroughly cleaned or replaced if necessary.
-
Verified
Quality Work -
Guaranteed
Fair Prices -
Happy
Customers