Q&A

Can it be changed without pulling the motor?

Oil is beginning to seep out from between the motor and oil pan.

The pedal slowly has gotten more and more close to the floorboard. And now it is all the way to t...

truck will not start,tried starting fluid,i no was last resort,got this truck after so called tec...

When the S10 sits, like overnight, the lifters make noise for a minute or two when it is first st...

which is eaiser pull the motor(replacing it's bad) or pull the motor w/ trans? trans is a tw...

plate/ tourque converter bolts. i found an inspection plate bout 2" in dia. but no acess, th...

No hot air, no coolant leaks, hoses seem ok, water hoses feel hot but
no hot air. engine runs at...

Pitman arm shaft seal is leaking. I need a part explosion so I can have a better idea how its in ...

code shows bad knock sensor,what are the effects of a bad knock sensor,and where is it located on...

i put new heater core ,new radiator,new water pump ,new thermostat,and a new fan clutch on and st...

I have a 2002 S=10 with a 2.2 liter engine.Last year ,the a/c went out and I am replacing the com...

I have replaced Master Cylinder ,wheel cylinders hard wear,shoes.and had drums turned still no ...

Got off work Feb 2 after 5 weeks offshore cranked the truck a couple miles down the road servicw ...

just started ...i have checked wheels for heat but none there....could it be tires?