1997 Chevrolet S10 Questions

Unanswered 1997 Chevrolet S10 Questions

Ask a Question
View:RecentAnsweredUnanswered
I had two lines bust on frame behind a-plate when stoping quickly while towing a trailer pedal went to the floor I changed the line and blead brakes now I got a hard pedal and no brakes can u tell me y
Do I have to remove cylinder head to replace the noisy lifter
I suspect ignition switch. wires to battery and starter and alternator seem fine. Disconnected battery and when re-hooked it sparked like a short somewhere but no smoke or melted wires.
I am losing about a quart of antifreeze every two weeks Oil is clean no traces of antifreeze Where is this going? How do I tell if it's the gasket? Water pump?
problem occurs everytime I try and start it what could be the problem
Fuel line leaking where it goes into the motor but can not get the line off.
heater control on dash will not adjust to cold always blows hot flapper door for defrost and floor works, have replaced vacum lines at the vac ball under the hood on drivers side can anyone help thanks
how do you disconnect slave cylinder from tranny ?
WHEN I START MY TRUCK IT SEEMS TO BE IDEAL FAST AND WHEN I PUT IT IN GEAR IT JUMPS '
fuel pump started to act up and now won't start. had it towed home thinking it was the fuel pump again but i have no power to instrument panel or comunication with code reader. fuses and relays are ok. what is the ECM...