1995 Chevrolet S10 Problems

RepairPal has identified the most common problems with the 1995 Chevrolet S10 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
21
Known Problems

The serpentine belt tensioner can fail; it may become noisy and/or the belt may jump off. Replacement of the failed tensioner will be necessary.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

The headlight switch used on the Chevrolet S10 is known to fail through normal operation. Since the headlight switch is also integrated into the interior lights, a malfunctioning switch can cause issues with interior lights as well.

  • Symptoms of a failed headlight switch include:
  • Headlights and taillights failing to turn on or off
  • Interior lights flicker, or fail to turn on or off
  • Gauge cluster lighting off or flickering with headlights on
  • Parking light malfunctions  

This issue is well known with General Motors Trucks and SUVs, and is solved by testing and, if needed, replacing the headlight/dimmer switch. Bad grounding wires at the tail-lights, and dirty/corroded tow package wires can also lead to some of these issues. 

The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.

The alternator may fail, causing a "no charge" condition. An internal bearing may also fail and cause an abnormal noise. If the vehicle is driven too long with a failed bearing, the alternator may stop turning, which can cause the serpentine belt to break or the engine to stall and not turn over.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine  with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

GM recommends replacing the engine coolant at 100,000 miles; however, our technicians tell us that the coolant may become contaminated and require a complete cooling system flush every 60,000 to 70,000 miles.

The electrical contacts in the ignition switch may fail and result in erratic instrument panel gauge operation or illumination of the Check Engine Light. A failed ignition switch will require replacement.

The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.

A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.