Q&A

I changed the cap and wires .. no improvement..changed the pick up coil and the module..I have no...

is this the fault of the blower resistor? and how can i get to the resistor?

The vehicle will not start back immediately,and I have change the fuel regulator, injectors. The ...

After installing new flywheel clutch and pressure plate I'm trying to push the slave cylinde...

Doing a clutch pressure plate throw out bearing clutch fork and fork ball replacement when trying...

my heater core is leaking...do I have to replace it or can I just not use heater?

I have a 92 s10 that cranks and runs great until it get warmed up at which time if you cut it off...

how tight do i get the valve covers

hot or cold it will miss only at steady speed getting up to speed is slugish replaced; map sensor...

Ceheck Engine light goes on after engine warms up...runs rough and idles up and down. 140,000 miles

I have only 42k miles (yes, only 42k)on my pickup, but my clutch is about to go out. In the old ...

I have recently replaced my coolant sensor because it was litterally broken in half. My vehicle ...

water pump is leakinfg behind fan is this an early warning sign that pump si going bad

This is the origional gasket, How do I get the valve cover off, I have removed the bolts, undid t...