1992 Chevrolet S10 Questions

Unanswered 1992 Chevrolet S10 Questions

Ask a Question
View:RecentAnsweredUnanswered
I have change out the entire system, master cycl, slave cyl.,and pressure hose. I tried to bench bleed the entire system. cup, hose, master, pressure line, slave. I got a lot of bubbles out of it, when I was bleeding ...
is this the fault of the blower resistor? and how can i get to the resistor?
thursday night ran fine, friday night wouldn't start. saw arching from coil wire, saturday moring changed all the wire one at a time like i was told, now it dump fuel in to the intake like u were pouring it in. wat sh...
After installing new flywheel clutch and pressure plate I'm trying to push the slave cylinder rod back into the slave cylinder forcing the fluid back to the clutch resevor just as you do when forcing a brake caliper b...
I have a 92 s10 that cranks and runs great until it get warmed up at which time if you cut it off it doesnt want to crank back till it cools i have had the electrical side checked all is good.After you cut it off the ...
This is the origional gasket, How do I get the valve cover off, I have removed the bolts, undid the wires, and lines. There is a bracket at the back supporting a hard line, with part of the wiring harness passing betw...
I have replace all 3 switches in the control panel, the blower motor resistor on the firewall, have checked every vaccum hose that i can see. I only get air flow to the floor and the blower only works on high. How do ...