The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.
Problems for specific Chevrolet S10 years:
Car problem reports
Report A Problem
Problem with your car? See what our experts say or submit your own.
Newest reported 1992 Chevrolet S10 problems
Intake Manifold Gasket May Leak Coolant or Engine Oil
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.
6 Reports
Power Window Motor May Fail
A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.
13 Reports
Oil Leak From Distributor Shaft Seal
6 Reports
Transmission Leak From Output Shaft Seal
A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.
5 Reports
Check Engine Light and Erratic Gauge Operation
The electrical contacts in the ignition switch may fail and result in erratic instrument panel gauge operation or illumination of the Check Engine Light. A failed ignition switch will require replacement.
10 Reports
Rough Idle and Check Engine Light Due to Sruck Open EGR Valve
4.3L V6 multi-port FI only
The exhaust gas recirculation valve (EGR) may stick open causing a rough idle and the Check Engine Light to illuminate. Our technicians tell us that a piece of carbon may become stuck in the valve causing this problem. Cleaning the valve will usually correct this condition, in some rare cases the valve will need to be replaced.
1 Report
Engine Oil Leak From Valve Cover Gasket
This engine may leak oil from the valve cover gasket.
4 Reports
Coolant Leak From Heater Core
The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.
29 Reports
Coolant Leak & Engine Overheating
A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.
7 Reports
ABS Light Due to Brake System Control Unit Failure
The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.
22 Reports
Power Door Locks Stop Working
The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.
9 Reports
Check Engine Light Due to Oxygen Sensor Failure
The oxygen sensor can fail causing Check Engine Light illumination and the engine to run rich (burn more fuel than normal).
7 Reports
Failed alternator can cause "no charge" condition
The alternator may fail, causing a "no charge" condition. An internal bearing may also fail and cause an abnormal noise. If the vehicle is driven too long with a failed bearing, the alternator may stop turning, which can cause the serpentine belt to break or the engine to stall and not turn over.
6 Reports
Timing gears can cause knocking sound
Timing gears may wear causing a mild to severe knocking noise from the front of the engine. Replacement of the timing gears is necessary.
5 Reports